rssLink RSS for all categories
 
icon_orange
icon_green
icon_green
icon_red
icon_red
icon_green
icon_green
icon_orange
icon_red
icon_red
icon_green
icon_green
icon_green
icon_blue
icon_orange
icon_red
icon_green
icon_blue
icon_orange
icon_red
icon_green
icon_red
icon_green
icon_blue
icon_orange
icon_red
icon_green
icon_blue
icon_green
icon_blue
icon_red
icon_green
 

FS#5203 — mise à jour ACE astuce

Attached to Project— Reseau Internet et Baies
Maintenance
Tout le réseau
CLOSED
100%
b. After the image is copied to the supervisor engine, access configuration mode and set the boot
variable for the ACE and the image. For example, to access configuration mode and set the boot
variable if the ACE is in slot 3, enter:
Router# config t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#boot device module 3 disk0:c6ace-t1k9-mz.A2_1.bin
Device BOOT variable = disk0:c6ace-t1k9-mz.A2_1.bin
Warning: Device list is not verified
Router#
From the ACE, perform the following steps:
a. Boot the ACE from the image on the supervisor engine by using the boot eobc command.
rommon 1> boot eobc:

Date:  Thursday, 03 March 2011, 21:43PM
Reason for closing:  Done